![]() ![]() The current version of HEC-RAS can perform either steady or unsteady flow computations. The other data types are only required if you are going to do that specific type of analysis (i.e., steady flow data are required to perform a steady flow water surface profile computation). Geometric data are required for any of the analyses performed within HEC-RAS. The data needed to perform these computations are divided into the following categories: geometric data steady flow data unsteady flow data sediment data and water quality data. ![]() The main objective of the HEC-RAS program is quite simple - to compute water surface elevations at all locations of interest for either a given set of flow data (steady flow simulation), or by routing hydrographs through the system (unsteady flow simulation). For information of data requirements for 2D modeling, please review the 2D Modeling User's manual. Nodes do not come with a data property that is required. ![]() The primary use case for a basicdata entity and NOT a node entity is not complicated. The entity type is basicdata and you may add any fielded bundles youd need. The basic data are defined and discussions of applicable ranges for parameters are provided. Basic Data is a content entity that ships with an additional data property. The software can also control our Programmable stimulator modules, requires 73-0224 Software module for PSM control and the necessary PSM hardware.This chapter describes the basic data requirements for performing the one-dimensional flow calculations within HEC-RAS. heart rate or respiration rate, depending on what is measured.Īdditional available software modules: 73-2706
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |